Notice: Where it is usually achievable to gain access to the ASIO handle screen from within the audio software from within the audio program, you should, you should use that option instead of pressing the holder icon! make use of that option rather of clicking the holder image! Be aware: Where it is usually probable to access the ASIO handle board You can deactivate balloon notices by changing to “Advanced” setting in the ASIO4ALL control panel. If there can be no holder image, your audio application is not currently making use of the ASIO4ALL drivers. The tray icon will become noticeable whenever an software initializes the ASIO4ALL car owner. For configuring ASIO4ALL with these programs anyway, you can release the handle section by clicking on on the ASIO4ALL position image in the System Tray region. some ASIO óutput plugins in press player software program. This will be the situation for elizabeth.g. Occasionally, the audio software program certainly would not supply an ASIO handle panel option. Please seek advice from the manual of your audio software for further support, if essential! Once you push this button, the ASIO4ALL control screen should show up. How this key is labeled depends on your particular software. There right now should end up being a switch to start the ASIO control board.

Usually, you would usually enter the sound configuration menus and go for ASIO -gt ASI04ALL v2.

How you would perform this depends on your particular software application. However, I would uninstall ReaRouteASIO if I were you.- In purchase to create make use of of ASIO4ALL, you require to configure your audio software accordingly. And shame to know your audio card does not show properly via WASAPI. Oh sorry, I posted the WASAPI method, because I faced similar problems with ASIO and found that WASAPI and Reaper are very stable together on W10. I am going to try and lower the samples from 512 to 128 and see what happens. I also just found this thread: which is similar to what I am experiencing, so I guess there is no real fix. I did look into using the WASAPI method and when I select my Alesis Audio Interface as the Input, Reaper doesn't show the individual line ins for each output from the audio interface all it shows is ReaRoute 1-16 So the issue is when I use Reaper for a while, stop recording, start recording, playback, etc, the audio will start to go scratchy/distorted.

So I am not using the WASAPI method, I am using ASIO.

Asio4all unavailable output